I need help with...

Floor Graphics Installation

Whether you design them for promotion, decor or directional signage, custom Floor Graphics make great marketing assets for any business or industry. Adhesive-backed, our floor decals can be applied to commercial-grade tile, sealed concrete, linoleum, asphalt, other similar non-porous flooring and even carpet.

After you’ve finished online printing and are ready to apply your vinyl floor stickers, follow the instructions below or download them here.

Before You Begin

These instructions are intended for the dry application of both one-sided and two-sided floor graphics.

  • Temperature may impact the installation process. We recommend installing graphics in temperatures between 40-90° F for optimal adhesion.
  • If your graphics are larger than 18” x 24”, have a complex design, overlap, are tiled or simply a difficult undertaking, we recommend considering hiring a professional installer.

What You’ll Need

Not all of these tools are necessary. What you need may vary, depending on the install method you choose and the level of difficulty.

  • Printed floor graphics
  • Tape measure or measuring tool
  • Multi-surface cleaner and a lint-free cloth
  • Masking tape or painter’s tape
  • Hand applicator or a credit/debit card
  • Rubber roller
  • Safety pin

Prep Your Surface

A clean surface is essential to the installation of any adhesive graphic. Use a multi-purpose cleaner to thoroughly clean the surface free of any dirt, dust, grease or other debris that may affect the adhesion process.

We recommend doing a final wipe down with water and a lint-free cloth to clear any other matter or chemicals from the cleaners that could also affect adhesion.

If you have access to Iso-propyl alcohol (IPA), a final wipe down with this is more favorable than water, but not necessary.

Apply Your Graphics

Step 1

With the surface of the application (the floor) ready, find the center of your printed graphic. Center your graphic and note where the top is. You can do this either by:

Holding the graphic in place:

O marking where the top of the graphic will be with tape:

Step 2

If you’ve marked the top of your graphic with tape (away from the installation surface), peel back the release liner from the graphics.

If you’ve taped your graphics to the surface, peel back a corner, lift the graphics up from the bottom and remove the rest of the liner, being careful to not pull the graphics away from the install surface.

Step 3

Set your graphics back to your marks. Or with the top edge of the graphic already in place, use a hand applicator to smooth the top edge down and out from the center. A credit/debit card can be used for this.

We also recommend placing a piece of masking or painter’s tape at the edge of the applicator to minimize the risk of scratching the graphics.

Step 4

After smoothing your graphic, use a rubber roller (if you have one) and roll across it to press out any air bubbles. This will create a better seal to the surface.

If air bubbles persist, use a pin and poke a hole in any that stand out to release the air.

If there are too many bubbles, you may have to peel back the graphic and redo the smoothing process.

Step 5

Wipe away any water residue from the smoothing process.

Since these are adhesive-backed graphics, adhesion will take place immediately.

 

Installing window clings, decals or SEGs? Apply them easily with the simple steps on our Installation Instructions page. If you have any questions about this or any of our online printing services, please contact customer service.

Still can't find what you're looking for?